The new line of FullPower lipo batteries for receiving power supplies (RX), equipped with silicone cable and UNI plug (JR type).<\/p>\n
For good performance and long life of the Li-Fe battery packs, it is recommended to balance them during charging using special tools.<\/p>\n
Fullpower batteries are suitable for a charge up to 5C (five times the battery capacity), however, if there is no particular urgency, a charge of up to 1C is recommended, this – and applies to all types of batteries – extends it noticeably life.<\/p>\n
ATTENTION, BEFORE PURCHASE READ CAREFULLY:<\/span> IMPORTANT:<\/span> Charge: It is strongly recommended not to exceed 3.6V per cell in charge and not to drop below 2.5V per cell in discharge, otherwise, the battery will deteriorate rapidly.<\/p>\n Fullpower batteries are suitable for a charge up to 5C (five times the battery capacity), however, if there is no particular urgency, a charge of up to 1C is recommended, this – and applies to all types of batteries – extends it noticeably life. However, it is recommended to carry out the first 2\/3 charges at 0.5 or 1C.
\nBatteries, electric motors, propellers and models are highly technological products but potentially dangerous for things, animals or people, especially if used improperly or without experience. By purchasing these products, the buyer assumes all responsibility for the risks listed below, agreeing not to hold the producers, distributors, or retailers responsible for any accidents to things, animals or people in any way.<\/span><\/p>\n
\nAfter use, always disconnect the battery from any circuit (receivers, speed regulators, etc.), these generally continue to absorb energy even with the power switch off, over-discharging the battery and irreparably damaging it.<\/p>\n
\nLi-Fe batteries require specific charging requirements and ONLY chargers with settings for Li-Fe cells must be used.
\nThe best chargers are those that require manual selection of the number of cells and of the charging current for each battery pack and which then automatically check that the settings are correct.
\nMany chargers are manually programmable but may not have a safety circuit that controls the settings. Incorrect setting of the charger can cause damage to the battery with the consequent risk of fire.<\/p>\n
\nFor good performance, duration and SAFETY of the Li-Fe battery packs, it is recommended to always balance them during charging using special tools. FullPower batteries are equipped with a JST-XH type balance connector.<\/span><\/p>","protected":false},"excerpt":{"rendered":"\n