H/W Seaking 180A Brushless ESC w/ Water Cooling – 151B91

This is the new series of ZTW 32 Bit G2 90A ESCs which support 3 to 8S batteries with 6V/7.4V/8.4V 8A SBEC (receiver power supply), the design is new and narrower than the previous series.

The SEAL G2 series is specially designed for RC hulls, with a waterproof shell.

In order to protect the electronics, the motor and the batteries, the ESC has an electronic system that reduces power in the event of overheating or low battery voltage.

Key Features:

1. New generation electronics that resist large instantaneous absorptions.

2. Adopts high-performance 32-bit microprocessor, the operating frequency is up to 170MHz which gives the G2 sere esc higher computing capacity.

3. The waterproof design (rates as IP 67) allows this ESC to operate in wet conditions and features water cooling applied to a metal plate to ensure efficient heat dissipation.

4. Super smooth and accurate throttle linearity makes the ESC suitable for various types of hulls: mono, cat, F1 or reproductions.

5. The ESC has two driving modes for different applications: “forward only” and “forward and reverse”. (I do not recommend reverse if you have a flexible axle!)

7. Multiple Protections: start, overload, low voltage cut-off, signal loss, phase loss, over-current, abnormal supply voltage, overload protection.

8. Compatible with high rpm brushless motors and compatible with most motors on the market.

9. Support programming via phone app or LCD program card, operation easier and more convenient (ZTW Extra App adapter or LCD program box needed G2.)

Technical specifications

Continuous current (A): 90 amps

Inrush current (A): 540 amps

Voltage: 3-8S Lipo

BEC output for the receiver: 6V/7.4V/8.4V 8A – connectors fit the classic JR ones, they are also good on Futaba

Power Cable: 12 Gauge80mm-Red/80mm-Black

12 Gauge Motor Wire 65mm – Black

The throttle works in both forward and reverse gear or you can lock the reverse function for racing safety.

Optional programming with G2 LCD programming card.

Case Dimensions (Cables Not Included):

Length: 88mm

Width: 38mm

Height: 24mm

Weight: 110g